Hunter Fan Hunter Type - Manual (Page 7)

7
41908-01 • 09/28/09 • Hunter Fan Company
Steps 4-5 – 4-6
Low Profile Screw
Low Profile Washer
Steps 4-2 – 4-3
Downrod
Canopy
Canopy
Trim Ring
Setscrew
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
4-1. Unbundle the wires from the fan.
For Standard or Angled mounting:
4-2. To assemble fan to hang down from a flat or angled ceiling, insert
the downrod through the canopy and canopy trim ring. Feed the
wires from the fan through the downrod.
4-3. Loosen the square head setscrew on the adapter to install the pipe
and ball assembly. Note: When the pipe and ball assembly is fully
installed, 2-3 threads on the pipe will still be visible; this is normal.
Securely retighten the setscrew with a wrench or pliers. Skip to
Step 4-7.
CAUTION: The adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
For Low Profile mounting:
Note: For low profile mounting, the downrod is replaced with the low
profile washer.
4-4. Remove the setscrew from the adapter.
4-5. Place the low profile washer (lip up) into the canopy. Be sure the
green ground wire is pointing up toward the ceiling.
4-6. Align the holes in the washer with the holes in the adapter.
Assemble securely with three low profile screws.
4-7. Raise the fan and place the hook on the ceiling plate through the
U-shaped hole in the rim.
Step 4-7
U-shaped
Hole
4 • Assembling and Hanging the Fan