Harbor Freight Tools 93033 - Manual (Page 6)

Page 6 SKU 93033 For technical questions, please call 1-800-444-3353.
Operation
Warning!! Never work on a vehicle that is on the ATV Motorcycle Jack, or leave it unat-
tended, if the Stop Bar (33 and 35) is not in place, or the Lock Bolts (37) are not engaged
(lifting the casters off of the ground).
Note: Keep fingers and hands away from the Lift Arms (4 and 6) when raising or lowering the
Lift. Keep onlookers and children a safe distance from the Lift during operation.
Raising the Lift.
Note: Use a second person to assist, if needed.
1. Use the Handle (1) to roll this product and position it next to the load you wish to lift. To
lower the lift so it will fit under the load, gently depress the Release Pedal (26).
Note: Check the load manual for recommended lifting points.
2. Once positioned under the load at the correct lifting points, turn the Lock Bolts (37) until
they contact the ground and lift the Swivel Casters (20) slightly off of the ground, to keep the
lift from rolling.
3. Use tie-down straps (not included) to secure the load. Repeatedly depress the Foot
Pedal (24) slowly, to raise the Saddle Platform (5). When the lift makes contact with the load,
make sure the load sits evenly on the two Saddle Platform (5) before raising the load off of the
ground. If the load is not evenly distributed on the Saddle Platform (5) and it not secured in
place with tie-down straps, it may fall from the Saddle Platform (5), resulting in possible per-
sonal injury and property damage.
4. Continue to raise the lift until you reach the desired height. Disengage the Stop Bar (3) from
the spring. You must lock the lift at one of the four locking positions with the Stop Bar (3). See
FIGURE 2.
5. This is a lifting device only. It is not designed to support loads for extended periods of
time. Do not work directly under the ATV lift.
Lowering the ATV Motorcycle Jack.
Note: Remove all tools from under the lift before lowering.
1. Depress the Foot Pedal (24) slowly to raise the lift enough to disengage the Stop Bar (3).
Lift it up and attach it to the spring.
2. Make sure everyone is clear and slowly depress the Release Pedal (26) to lower the lift.
NOTE: The Rear Pedal is designed with a Safety Valve, so it needs to be pressed down
only part way to lower the load. Once the load is on the ground, remove the tie-down straps
(not included). When the lift is clear of the load, turn the Lock Bolts (37) until they are clear of
the ground, allowing the Swivel Casters (20) to firmly contact the ground. Roll the ATV Motor-
cycle Jack clear of the load.
Maintenance
1. Keep your ATV Motorcycle Jack dry, protecting it from wet, corrosive environments.
2. Periodically lubricate the Jack’s moving parts.
3. Periodically check that all of the Jack’s hardware is securely fastened.
If the Jack does not work to full capacity, you may have air in the hydraulic system.