Harbor Freight Tools 66552 - Manual (Page 5)

SKU 66552 For technical questions, please call 1-800-444-3353. Page 5
Hole in foot on Base (2); •
Washer (9); •
Remaining hole in second Mounting •
Bracket (5);
Washer (9).
•
Secure Short Bolt with Lock Nut (8).
7.
Before using the Bike Stand with a 8.
load, test the operation of the Pedal
and Release Bar, without any load,
following the operating instructions
below.
operating instructions
read the entire iMportant
saFetY inForMation
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Locate Stand on hard, flat, and level 1.
surface able to withstand load without
deforming.
Center dirt bike over Saddle and
2. se-
cure to saddle with tie-down strap
(sold separately) before lifting.
Using second person to stabilize
3.
load, slowly raise Saddle by de-
pressing Pedal with your foot until
Saddle is fully raised.
locking
pin (11)
r-pin
(12)
4. Insert Locking Pin (11) fully through
the hole in the saddle and the base
to secure the stand in the up position.
Lock it in place with the R-Pin (12)
5. Warning! stay clear of release
bar while saddle is elevated and in
use.
Remove tools from under stand be-
6.
fore lowering.
To lower Saddle, keep clear and
7.
remove the R-Pin and Locking Pin.
Place foot on Release Bar and Pedal.
Using second person to stabilize
load, press on Release bar while
guiding Pedal up to smoothly lower
Saddle.