Hunter Fan 44758 - Manual (Page 2)

Hunter Fan Co.
2500 FRISCO
AVENUE
MEMPHIS, TN 38114
© 2008 Hunter Fan Company Form No. 44004-01 Rev 09/04/2008
5) Place the Battery Compartment Cover
over the Battery Compartment.
6) For Wall Mounting
a. Replace the Outer Cover as
shown in Figure 8. Use the four screws to
secure the Outer Cover.
b. Use the provided screw to
mount the Remote Sensor on a wall or
other vertical surface. The back of the
Remote Sensor has a Wall-Mount Indent
from which it will hang from the provided
screw. See Figure 9
Figure 8
Wall-Mount
Indent
Figure 9
6) To Set the Remote Sensor on a Table
a. Replace the Outer Cover as
shown in Figure 10. Use the four screws
to secure the Outer Cover.
b. Rest the Remote sensor on
the horizontal surface of your choice.
Figure 10
Indications
Ch TEMP Ch TEMP
Normal Temperature Indication
If your Remote Sensor is set to show the
temperature in Celsius, the display will
show the ºC indication next to the tem-
perature. See Figure 11.
Ch TEMP
C
Figure 11
Temperature Measurement Range
Your Remote Sensor will show tempera-
tures from -40ºF to 122ºF (-40ºC to 50ºC).
If the temperature is greater than 122ºF
(50ºC), the LCD will show “HI”. See Fig-
ure 12A. If the temperature is lower than
-40ºF (-40ºC), the LCD will show “LO”.
See Figure 12B.
Figure 12A
Figure 13
Figure 12B
Low Battery Indication
When your Remote Sensor’s battery is
running low, the LCD will show the flash-
ing Low Battery Indication to remind you
to install two fresh AA Alkaline batteries
at your earliest convenience. See Figure
13. At this point your Remote Sensor will
continue to function normally.
Ch TEMP
Depleted Battery Indication
If your Remote Sensor’s battery is deplet-
ed to the point that the LCD is showing
only the flashing Low Battery Indication,
as in Figure 14, your Remote Sensor has
ceased functioning and will continue in
this condition until two fresh AA Alkaline
batteries are installed. Without further at-
tention, the LCD will eventually go blank.
Your Remote Sensor will return to nor-
mal operation when fresh batteries are
installed.
Figure 14
Troubleshooting
Problem: LCD is Blank.
Solution: Make certain your Remote Sen-
sor’s batteries are 1) installed correctly,
with polarities correctly positioned, and 2)
fresh.
Problem: Thermostat is not showing the
same temperature as the Remote Sensor.
Solution: Make certain you have the cor-
rect Remote Sensor selected at your ther-
mostat (if you are using more than one
Remote Sensor).
If you require further assistance, call Hunter
Fan Technical Support at 1-888-830-1326
from 7am to 7pm Central Time Monday thru
Friday and 8am to 5pm on Saturday.
4. The Remote Sensor Screen will dis-
play the ambient temperature and, in the
bottom-left corner, a channel number
between 0 and 15. See Figure 7. This will
be the channel to which you will set the
thermostat to read the Remote Sensor.
See the Thermostat Instruction Manual,
page 14, Option 8.
Ch TEMP
3. The LCD Display will then show the
normal operating screen. See Figure 7.
NOTE: It may take up to 30 seconds for
the thermostat to "pick-up" the sensor.
Figure 7
Channel