Hunter Fan 44758 User Manual

Ch rhtemp c, Operation

TEMP

Form No. 44004-01 Rev 09/04/2008

Your Model 44665 thermostat can read

the temperatures from up to three weath-

er-resistant sensors at a distance of up

to 75 feet*. It will control the temperature

from as many as two indoor sensors, with

a third being a sensor only - perfect for

outdoor use.
If you use multiple sensors, you might

want to number them. Simply use a mark-

er to write a number on the back of each

sensor.
Additional sensors can be pur-

chased separately from your HVAC

contractor, or you can contact us at

www.climatetechnologyproducts.com.
You can mount the Remote Sensors on

a wall or other vertical surfaces, or you

can set the Remote Sensors on tables or

other horizontal surfaces.
Consult the Thermostat Instruction Man-

ual, page 15, Option 8 for instructions in

setting the thermostat to accommodate

the remote sensors.
* Distance my vary based on building con-

struction or other interfering frequencies.

Model 44758

Remote

Sensor

Owners

Manual

NOTE

This device complies with Part 15 of the FCC

Rules. Operation is subject to the following

two conditions: (1) this device may not cause

harmful interference, and (2) this device must

accept any interference received, includ-

ing interference that may cause undesired

operation.
This equipment has been tested and found

to comply with the limits for a Class B digi-

tal device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide

reasonable protection against harmful

interference in a residential installation. This

equipment generates, uses and can radiate

radio frequency energy and, if not installed

and used in accordance with the instruc-

tions, may cause harmful interference to

radio communications. However, there is no

guarantee that interference will not occur in a

particular installation. If this equipment does

cause harmful interference to radio or televi-

sion reception, which can be determined by

turning the equipment off and on, the user is

encouraged to try to correct the interference

by one or more of the following measures:
• Increase the separation between the

equipment and receiver.

• Connect the equipment into an outlet on

a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced

radio/TV technician for help.

1. Remove the four screws on the back

of the Remote Sensor. See Figure 1. The

Outer Cover will drop off.

Figure 1

2. Remove the Battery Compartment

Cover, which is underneath the Outer

Cover. See Figure 2.

Outer Cover

4. Install two fresh AA alkaline batter-

ies into the Battery Compartment, being

careful to observe the battery polarities.

See Figure 4.

Figure 2

Battery

Compart-

ment Cover

Battery

Compart-

ment

(Batteries

installed)

Figure 3

3. Use the tip of a paper clip to set the

FIRST FOUR Remote Sensor DIP Switch-

es to any configuration you desire. NOTE:

Each sensor you use must have a differ-

ent setting. See Figure 3.

To set the remote sensor to display the

temperature in Fahrenheit, place the

FIFTH DIP switch in the DOWN position.

To set the remote sensor to display the

temperature in Celsius, place the FIFTH

DIP switch in the DOWN position.

Figure 4

OPERATION

Initial Start-Up

1. When the batteries are installed, the

LCD Display will show the first initializing

screen for approx. 2 seconds. See Figure

Ch RHTEMP

2. The LCD Display will then show the

second initializing screen for approx. 10

seconds. See Figure 6.

Figure 5

Figure 6

DIP

1 2

3 4 5