Hitachi VT-FX795A - Manual (Page 2)

– 2 – EN
1. POWER button
2. NUMBER buttons
3. MENU button
4. DISPLAY button
5. PLAY button
6. REW button
7. REC button
8. SEARCH MODE button
9. TAPE SPEED button
10. PAUSE button
11. STOP button
12. F.FWD button
13. COUNTER RESET/EXIT button
14. COUNTER MEMORY button
15. SLOW button
16. CH buttons
17. EJECT button
18. VCR / TV button
( )
19. AUDIO OUT jacks
20. AUDIO IN jacks
21. ANT. IN jack
22. ANT. OUT jack 23. VIDEO IN jack
24. VIDEO OUT jack
25. AC Power Cord
Display Window
1
2 3 4 5 6 7 8 9 10 11 12
POWER CHANNEL
TRACKING L-AUDIO IN-R VIDEO IN
REC/IRT STOP/EJECT REW PLAY F.FWD
n m a b s PN V
14
15
16
17
18 13
Remote Control
SLOW
TAPE SPEED
SEARCH MODE
CH
PAUSE REC
DISPLAY EXIT MENU COUNTER
RESET MEMORY
POWER EJECT
0
REW
STOP
PLAY
F.FWD
7 8 9
6 5 4
3 2 1
VCR/TV
1
2
16
17
3
6
7
14
15
12
9
18
11
10
8
13
4
5
Rear Panel
ANT AUDIO
VIDEO
IN
OUT
OUT IN
OUT
L
R
IN
25
19 20 21
24 23 22
Install Location
For safety and optimum performance of your VCR:
• Install the VCR in a horizontal and stable position. Do not place
anything directly on top of the VCR. Do not place the VCR directly
on top of the TV.
• Shield it from direct sunlight and keep it away from sources of
intense heat. Avoid dusty or humid places. Avoid places with insuffi-
cient ventilation for proper heat dissipation. Do not block the ventila-
tion holes on the sides of the VCR. Avoid locations subject to strong
vibration or strong magnetic fields.
Avoid the Hazards of Electrical Shock and Fire
• Do not handle the power cord with wet hands.
• Do not pull on the power cord when disconnecting it from AC wall
outlet. Grasp it by the plug.
Moisture Condensation Warning
Moisture condensation may occur inside the unit when it is moved
from a cold place to a warm place, or after heating a cold room or
under conditions of high humidity. Do not use the VCR at least for 2
hours until its inside is dry.
FCC Warning
This equipment may generate or use radio frequency energy.
Changes or modifications to this equipment may cause harmful inter-
ference unless the modifications are expressly approved in the
instruction manual. The user could lose the authority to operate this
equipment if an unauthorized change or modification is made.
Important Copyright Information
Unauthorized recording or use of broadcast television programming,
video tape, film or other copyrighted material may violate applicable
copyright laws. We assume no responsibility for the unauthorized
duplication, use, or other acts which infringe upon the rights of copy-
right owners.
A Note about Recycling
This product's packaging materials are recyclable and can be reused.
Please dispose of any materials in accordance with your local recy-
cling regulations. Batteries should never be thrown away or incinerat-
ed but disposed of in accordance with your local regulations concern-
ing chemical wastes.
Note to the Cable TV System Installer
This reminder is provided to call the Cable TV system installer’s
attention to Article 820-40 of the National Electrical Code, which pro-
vides guidelines for proper grounding – in particular, specifying that
the cable ground shall be connected to the grounding system of the
building, as close to the point of cable entry as possible.
NOTE:
This product may contain lead and mercury. Disposal of these materials
be regulated due to environmental considerations. For the disposal or
recycling information, Please contact your local authorities or the
Electronics industries Alliance : www.eiae.org.
Install two AA batteries
(supplied) matching the
polarity indicated on the
bottom of the remote
control.
1. Cassette Compartment
2. F.FWD button
3. PLAY button
4. REW button
5. STOP/EJECT button
6. REC/IRT button
7. Display Window 1 8. Remote Sensor
1 9.CHANNEL/TRACKING
19. buttons
10. POWER button
11. AUDIO Input jacks
12. VIDEO Input jack
( )
13. PWR. (POWER) indicator
14. TAPE IN indicator
15. VCR indicator 16. REC indicator
17. TIMER indicator
18. CLOCK indicator
To insert the batteries
CAUTION:
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF
PLUG TO WIDE SLOT, FULLY INSERT.
PRECAUTIONS
DESCRIPTION OF CONTROLS
Front Panel
VIDEO OUT JACK
Connect a video cable going to
the VIDEO IN jack of a cam-
corder, another VCR, a TV, or an
audio-visual system (laser disc
player, video disc player, etc.)
here.
AUDIO OUT JACKS
Connect the audio cables going
to the AUDIO IN jacks of a cam-
corder, another VCR, a stereo
amplifier, or an audio system
here.
VIDEO IN JACK
Connect a video cable coming
from the VIDEO OUT jack of a
camcorder, another VCR, or an
audio-visual source (laser disc
player, video disc player, etc.)
here.
AUDIO IN JACKS
Connect the audio cables com-
ing from the AUDIO OUT jacks
of a camcorder, another VCR, or
an audio source here.