Harman-Kardon HK3250 - Manual (Page 9)

BASIC OPERATION
1 Press the POWER button to turn
the power ON, the display panel
will then light up.
• When using the POWER button
on the remote control turn the unit
off, the unit will go into STANDBY
mode.
2 Select the desired program source
with the INPUT FUNCTION
SELECTOR buttons and the
selected input function appears in
the display.
3 When the TAPE MONITOR button
is set to ON so that the TAPE
indicator lights up, the selected
program source cannot be heard
from the speakers.
To listen to a program source
other than cassette deck be sure
to set the TAPE MONITOR button
to OFF.
4 Adjust the volume to a comfortable
listening level with the VOLUME
control or VOLUME UP/DOWN
buttons on the remote control.
5 For private listening, insert a 1/4
inch plug of the headphone into the
HEADPHONE jack.
• When the headphones are
plugged, sound from the
speakers is cut off.
LISTENING TO BROADCASTS
You can use auto, manual or preset
tuning to select a radio station.
AUTO TUNING
If broadcast signals are strong and
there is no interference, auto tuning is
possible.
1 Press the FM or AM button to
select the desired band.
2 Press the SEEK STEREO button
and AUTO will illuminate in the
display.
3 Press the TUNE UP/DOWN button.
Tuning will start automatically and
stop at a broadcast station
frequency with sufficient signal
strength.
MANUAL TUNING
Auto tuning may be impossible if the
broadcast signal is weak. If so, use
manual tuning.
1 Press the FM or AM button to
select the desired band.
2 Press the SEEK/STEREO button
and AUTO will go out in the display.
3 Press the UP or DOWN
TUNE/PRESET button until the
desired station frequency is
reached.
• Each time the button is pressed,
the frequency changes by a step.
• When the button is kept pressed,
the frequency changes
continuously in sequence.
PRESET TUNING
The receiver has a memory for up to
30 preset stations.
If the station frequencies are stored in
this memory, they can be tuned in by
a simplified procedure.
MANUAL PRESETTING
Up to 30 stations can be preset at
random, regardless of the reception
band.
1 Tune in the station to be
memorized using the auto or
manual tuning.
2 Press the MEMORY button, then
the MEMORY indicator lights up for
5 seconds.
3 Select the channel number with the
UP or DOWN TUNE/PRESET
NUMERIC buttons on the remote
while the MEMORY indicator is lit,
then the selected channel number
lights up.
4 Press the MEMORY button to
memorize the station.
• When using the NUMERIC
buttons on the remote, the station
is memorized without pressing
the MEMORY button again.
• When selecting one digit channel
number with the NUMERIC
buttons, press the corresponding
number without “0”.
5 Repeat steps 1 to 4 to preset other
stations.
7
Operation
ENGLISH
HK3250 engelsk 11/01/98 14:28 Side 7