Harman-Kardon HK3250 - Manual (Page 10)

RECALLING THE PRESET
STATIONS
Select the channel number of the
desired preset station with the UP or
DOWN TUNE/PRESET or NUMERIC
buttons on the remote control unit.
SCANNING THE PRESET
STATIONS IN SEQUENCE
1 Press the PRESET SCAN button
on the remote control unit to listen
to the preset stations.
2 The receiver will start scanning the
stations in the preset sequence
and each station is received for 4
seconds.
3 At the desired station, press again
to stop scanning.
NOTES:
• If the end of the frequency range is
reached during the auto or manual
tuning, tuning will continue from the
opposite end.
• When FM stereo broadcasts are
poor, select the FM mono mode
with the SEEK/STEREO button so
that the AUTO indicator goes out.
• When memorizing a new station,
the previously memorized station
on the same channel number is
cleared.
• In the event of a power failure or
when the receiver is disconnected
from the AC outlet, the memorized
stations are maintained for
approximately 2 weeks.
RECORDING WITH A
CASSETTE DECK
1 Select the program source to be
recorded with the INPUT
FUNCTION SELECTOR buttons.
2 Start recording on the cassette
deck.
3 Play back the desired program
source.
• The volume, balance, bass and
treble settings have no effect on
the recording or dubbing.
• When recording is performed on
a 3-head cassette deck, the
recorded sound can be monitored
through the speakers by pressing
the TAPE MONITOR button to
ON.
8
ENGLISH
HK3250 engelsk 11/01/98 14:28 Side 8