beautypg.com

Automatic shut off, Carrying handle, Brush setting selector – Hoover Deep Cleaner with Auto Rinse SteamVacuum User Manual

Page 8: The tanks, Rinse setting switch, Clean water tank, How to fill

background image

Automatic shut off

When the recovery tank (lower tank) is full
the automatic shutoff mechanism will shut
off the deep cleaner suction

(suction will

be noticeably reduced).

At that time, the yellow float disk will rise
to the top of the recovery tank lid (B).
The deep cleaner will no longer pick up
dirty solution and the

motor sound will

become noticeably higher in pitch.

When this happens, turn deep cleaner
off and empty recovery tank

before

continuing use.

Check clean water tank also; it may
need to be refilled.

Do not use without float and float
retainer in place. If broken or dis-
lodged, take to an Authorized Hoover
Service Center or Dealer for repair.

8

ON

OFF

WAS

H

AUT

O R

INS

E

Rin

se

Carrying handle

The deep cleaner may also be lifted by
placing a hand above the upper clean
solution tank handle as shown.

2-5

2-7

2-8

2-6

Brush setting selector

Your ‘SteamVac’ deep cleaner has two
agitator brush settings.

ON -

for cleaning of carpet and bare

floors

OFF -

for cleaning carpets and bare

floors when brushing is not desired.

Slide selector button to the desired set-
ting before cleaning.

B

C

D

2-10

2-9

The tanks

Clean water tank

(upper tank)

The clean water tank (C) holds the water
that will either be mixed with detergent
for cleaning the carpet or floor, or used
to rinse the carpet or floor.

The detergent container (D) is perma-
nently attached to the water tank. It
holds the detergent that mixes with the
water.

Rinse Setting switch

Use this switch to select a wash with
rinse setting or a rinse only setting.

WASH-AutoRinse

- This setting cleans

your carpet with detergent and water on
the forward stroke. On the reverse
stroke, a water-only rinse is applied
automatically.

RINSE

- This setting applies water-only

rinse in both the forward and reverse
strokes.

See “How to clean” section for more
details.

How to fill

Unplug deep cleaner from electrical
outlet.

Place deep cleaner handle in the
upright, locked position.
To remove tank, press down on tank
handle and pull forward.