HONDA GX35 - Manual (Page 16)

TAKING CARE OF UNEXPECTED PROBLEMS TECHNICAL & CONSUMER INFORMATION
ENGINE WILL
NOT START Possible Cause Correction TECHNICAL INFORMATION
Serial Number Location
Remote Control Linkage
Standard/Tiller type:
Correction Possible Cause ENGINE LACKS
POWER
ENGLISH
CABLE ATTACHMENT FITTING
LOCK NUT
THROTTLE CABLE
ADJUST NUT
STAY
ENGINE TYPE
ENGINE SERIAL NUMBER
16
Date Purchased: ______ / ______ / ______
Engine type: ___ ___ ___ ___
Engine serial number: __ __ __ __ __ __ __ __ __ __ __
The throttle control lever is provided with a fitting for cable
attachment.
Remove the air cleaner cover (see page ) for access to the
throttle lever and cable fitting.
Attach the throttle cable as shown in the illustration.
To adjust the throttle cable, follow the equipment manufacturer’s
instructions.
Record the engine serial
number, type and purchase
date in the space below. You
will need this information when
ordering parts and when
making technical or warranty
inquiries.
Choke open.
Engine switch
OFF.(on the
equipment)
Out of fuel.
Bad fuel; engine
stored without
treating or
draining
gasoline, or
refueled with
bad gasoline.
Spark plug faulty,
fouled, or
improperly
gapped.
Spark plug wet
with fuel
(flooded engine).
Fuel filter
restricted,
carburetor
malfunction,
ignition
malfunction,
valves stuck, etc.
Check control
positions.
Check fuel.
Remove and
inspect spark
plug.
Take engine to
an authorized
Honda
servicing
dealer, or refer
to shop
manual.
Filter element
restricted.
Bad fuel; engine
stored without
treating or
draining
gasoline, or
refueled with
bad gasoline.
Fuel filter
restricted,
carburetor
malfunction,
ignition
malfunction,
valves stuck, etc.
Check air filter.
Check fuel.
Take engine to
an authorized
Honda
servicing
dealer, or refer
to shop
manual.
Clean or replace
filter element
(p. 10).
Drain fuel tank and
carburetor (p. 15).
Refuel with fresh
gasoline (P. 8).
Replace or repair
faulty components
as necessary.
Move lever to
CLOSED position
unless the engine
is warm.
Turn engine switch
to ON position.
Refuel (p. 8).
Drain fuel tank and
carburetor (p. 15).
Refuel with fresh
gasoline(p. 8).
Gap or replace
spark plug (p. 11).
Allow the spark
plug to dry. After
drying, install the
spark plug and
start the engine
(p. 4).
Replace or repair
faulty components
as necessary.
1.
2.
3.
4.
1.
2.
3.
10
05/12/16 15:02:48 32Z6J600_016