hussmann P/N 0387183_D - Manual (Page 28)

CLEANING HONEYCOMB ASSEMBLIES
Honeycombs should be cleaned every six months.
Dirty honeycombs will cause merchandisers to
perform poorly. The honeycombs may be cleaned
with a vacuum cleaner. Soap and water may be
used if all water is removed from the honeycomb
cells before reassembling. Be careful not to
damage the honeycombs.
1. Remove the sheet metal screws located in the
front metal retainer which holds the honey-
comb assembly in place.
2. Lift the honeycomb assembly out of the
L-bracket to remove it.
3. Clean and dry the honeycomb.
4. After cleaning, reassemble in reverse order of
removal.
CLEANING UNDER MERCHANDISERS
Remove splashguards not sealed to floor. Use a
vacuum with a long wand attachment to remove
accumulated dust and debris from under the
merchandiser.
REMOVING SCRATCHES FROM BUMPER
Most scratches and dings can be removed using
the following procedure.
1. Use steel wool to smooth out the surface area
of the bumper or top rail.
2. Clean area.
3. Apply vinyl or car wax and polish surface for
a smooth glossy finish.
5-2 M
AINTENANCE
P/N 0387183_D WWW . HUSSMANN . COM
Honeycomb
Retainer
Top Panel
Interior
Top Panel
Screw
SIDE VIEW
Internal
Frame
Honeycomb
Adhesive
Do NOT allow product to sit in a
non-refrigerated area.
WARNING
!