Rear panel jacks, First time use – Hitachi 55HDX61 User Manual

Page 13

INSER

THIS

END

CableCARD

Digital Cable

REAR PANEL JACKS

After the CableCARD is installed, wait until the second screen below appears. The third screen below will appear if a channel is not
authorized for viewing. Press the EXIT button to exit the second screen.

Please take note of all information on the screen (you will provide this information to your cable operator). Call your cable operator
and give them the information from the card to start your cable service.

ት

CableCARD Slot
This slot is for the CableCARD that will be provided by your local cable operator to gain access to chosen cable channels. The
CableCARD will allow you to tune digital and high definition cable channels. Please call your local cable operator if this service is
available before requesting a CableCARD (also known as Point of Deployment (POD) module).

Connect a coaxial cable to ANT A terminal of the Rear Panel Jacks.
Insert the CableCARD into the slot (Top of card should be facing up as shown).

Rear Panel of AVC

If the CableCARD is properly installed or not installed, the TV will display the following respective screens.

CableCARD is installed

CableCARD

is not installed

In order to start cable service

for this device, please contact

your cable provider

CableCARD(tm): 123-456-789-1

Host: 123-456-789-1

Data: 123-456-789-1

UnitAddress: 123-456-789-1

Acquiring Data.

Please wait.

Press EXIT to return

Not an Authorized Channel

NOTES:

A digital cable subscription is required.

Antenna B will not be available when CableCARD is inserted.

Do not insert a PCMCIA card into the CableCARD slot.

Please see pages 63-64 for additional CableCARD information.

FIRST TIME USE