Hitachi LTIP/UX21511 - Manual

LTIP/UX21511, UX21513
R EPLACEMENT L AMP FOR H ITACHI LCD R EAR P ROJECTION T ELEVISION
M ODELS 42V515 / 42V710 / 42V715 / 50V500E / 60V500E / 50V500 / 50V500A / 50VX500 / 60VX500 / 60V500A /
50V710 / 50V715 / 60V710 / 60V715
R
EPLACING THE
L
AMP
U
SER
I
NSTRUCTIONS
CAUTION:
Do not attempt to remove the lamp immediately after use; doing so can cause serious burns. Prior to removing lamp, switch
off the power supply to the television and wait approximately 60 minutes or more to allow for complete lamp cooling.
Avoid touching the glass portion(s) of the lamp with bare hands; fingerprints, dirt and dust may cause early lamp failure
and/or image obscurity. It is recommended that gloves be worn when replacing the lamp.
When transporting the replacement lamp, use the box that is provided to avoid breakage.
.
.
.
To avoid overheating and/or fire, ensure that the replacement lamp is mounted securely.
The lamp contains mercury. Dispose of it in accordance with local environmental regulations. For disposal or
recycling information, contact your local authorities or see www.lamprecycle.org.
.
. WARNING:
1. Switch off power to the television. Unplug the power cord from the wall outlet. Allow the television to cool
for at least 1 hour.
3. Using a Phillips head screwdriver, remove the
screw securing the lamp cover; remove the cover.
®
4. Remove the two screws on the lamp unit. 5. Remove the lamp unit from the television by
grasping the handle and pulling it out. Dispose of
lamp in accordance with local environmental
regulations.
Note: To avoid injury, exercise caution when
removing the lamp unit and do not place your hand
in the lamp storage area.
2. Remove the front cover of the television by
pulling it outwards until the snap unlatches.
p. 1