haier 0010552537 - Manual (Page 9)

Parts and Functions
Used to select CODE A or B with a press,A or B
will be displayed on LCD.
Please select A without special explanation.
1.CODE
When the remote controller appears abnormal,
use a sharp pointed article to press this button
to reset the remote controller normal.
2.RESET
Used to select TIMER ON, TIMER OFF,
TIMER ON-OFF.
4. TIMER button
Used to set correct time.
5. CLOCK button
Used to select sleep mode.
6. SLEEP button
7. MODE button
AUTO COOL DRY FAN HEAT
Used to set clock and timer setting.
8. HOUR button
Used to set healthy operation.
9. HEALTH button
Used for unit start and stop.
10. ON/OFF button
11. TIMER ON display
12. FAN SPEED display
LOW HI MED AUTO
13. LOCK display
14. SWING UP/DOWN display
15. SLEEP display
16. HEALTH display
Used to select your desired temperature.
Operation mode AUTO HEAT FAN COO L DRY
Remote con troll er
18. Operation mode display
Display board
20. POWER/SOFT display
21. Left/right air flow display
Remote controller: to display the TEMP. setting.
22. TEMP display
23. TIMER OFF display
24. TIMER/SLEEP display
25. TEMP button
Used to select fan speed: LOW,MED, HI, AUTO.
26. FAN button
Used to set the health airflow mode.
27. HEALTH AIRFLOW button
28. SWING UP/DOWN button
Used to select up or down air sending direction.
29. SWING LEFT/RIGHT button
Used to select left/right air flow.
Used to confirm timer and clock settings.
30. SET button
31. POWER/SOFT button
Used to lock buttons and LCD display. If pressed, the
other buttons will be disabled and the lock condition
display appears. Press it once again, lock will be
canceled and lock condition display disappears.
32. LOCK
8
Every time the button is pressed,display changes
as follows:
33. Ambient temp.display
1 17
POWER SO FT
BLANK
17.FRESH AIR display
19.Singal sending display
3.LIGHT button
Control the lightening and extinguishing of
the indoor LED display board.
NOTE:(1) The following functions and related displays are not available:
(2) Cooling only unit do not have functions and displays related with heating.
HSU-09HV03/R2(DB)
HSU-12HV03/R2(DB)
HSU-07HV03/R2(DB)
HSU-18HV03/R2(DB)
When receiving the remote control signal, display the set
temperature and in the rest time the room temperature is
displayed and this room temperature is only for reference.
28
32
19
30
31
18 24 33 16 17