Harbor Freight Tools 35740 - Manual (Page 2)

SKU 35740 For technical questions, please call 1-800-444-3353. Page 2
SPECIFICATIONS
Characteristic Value
Tank Dimensions 17-3/8" x 14-1/4" x 8-3/4"
Max. Solvent Capacity 3-1/2 Gallons
Pump Output 50 GPH
Electrical Requirements .7 Amps @ 110V, 60Hz
Weight 15-1/2 lbs.
SAVE THIS MANUAL
You will need the manual for the safety warnings and
cautions, assembly instructions, operating procedures,
maintenance procedures, trouble shooting, parts list, and
diagram. Keep your invoice with this manual. Write the
invoice number on the inside of the front cover. Keep both this manual and your invoice in a
safe, dry place for future reference.
SAFETY WARNING & CAUTIONS
WARNING: When using electric tools, machines, or equipment, basic safety precautions should
always be followed to reduce the risk of fire, electric shock, and personal injury. READ ALL
INSTRUCTIONS BEFORE USING THIS TOOL!
1. KEEP WORK AREA CLEAN. Cluttered areas invite injuries.
2. KEEP CHILDREN AWAY. All children should be kept away from the work area. Don’t let
them handle tool.
3. DO NOT OPERATE THE PARTS WASHER IF UNDER THE INFLUENCE OF ALCOHOL
OR DRUGS. Read warning labels on prescriptions to determine if your judgment or
reflexes are impaired while taking drugs. If there is any doubt, do not attempt to operate.
4. READ ALL INFORMATION CONCERNING THE SOLVENT YOU ARE USING. Do not
use solvents with a flashpoint of less than 150°. Biodegradable solvents are recommended
as the use of mineral solvents or petroleum based solvents will cause premature pump
wear. Chlorinated solvents, e.g. 1-1-1 Trichloroethane and Methylene Chloride (also known
as methyl chloride) can chemically react with aluminum and may explode so are strictly
prohibited as this tool contain aluminum. If you are in any doubt whatsoever, contact the
solvent manufacturer.
5. DO NOT USE OR STORE NEAR OPEN FLAMES, PILOT LIGHTS IN STOVES OR
HEATERS, OR ANY OTHER HEAT SOURCE. Solvents are highly flammable. Always
make sure there is adequate ventilation. Extinguish all cigarettes when cleaning. Industrial
applications must follow OSHA requirements.
6. DO NOT OVERFILL THE PARTS WASHER. Do not fill above the level of the parts tray or
serious injury may occur.
7. MATERIALS USED WHEN CLEANING MAY BE HARMFUL OR FATAL IF INHALED
AND/OR SWALLOWED. Once again, when using the tool, always make sure there is
adequate ventilation. Always use a mask or respirator when close to fumes.
READ ALL INSTRUCTIONS
BEFORE ASSEMBLING OR
OPERATING THIS TOOL.
REV 05/05;06/05