Hotpoint BWM12 - Manual (Page 9)

Remember you may be
charged for a service
call if a problem with
your appliance is
caused by incorrect
installation or misuse.
Inserting the machine into the cabinet:-
- Push the machine into the opening, aligning it with the cabinets (Fig.8).
- Regulate the adjustable feet to raise the machine to the appropriate height.
- To adjust the position of the wooden panel in both the vertical and horizontal directions,
use the C and D screws, as shown in Fig.9.
Important: Close the lower part of the appliance front by ensuring that the plinth rests against the
floor.
9
Move the appliance into position, care must be taken that the Water Supply pipes and the
Drainage hose are not kinked or trapped.
Direct the mains cable towards the electrical socket to be used but DO NOT plug in at this
stage.
There must be at least 2mm clearance at the sides and top of the appliance. The back of
the appliance must also remain some distance away from the back wall. If the recessing cavity
is higher than 820mm, the opening between the floor and sides of the appliance (when
installed at the end of a line of furniture) must be completely closed in.
vi. Fitting your appliance into your
kitchen...
Fig. 8 Fig. 9