Huffy M732201 - Manual (Page 21)

01/06 ID# M732201
21
14. Roll the completed assembly to the desired playing area. Fill tank with 33 gallons of water.
15. Apply the height adjustment and moving label (25) to the front of the pole as shown.
24
24
10 ft.
(3.05 m)
25
TWO CAPABLE ADULTS
REQUIRED FOR THIS
PROCEDURE. FAILURE TO
FOLLOW THIS WARNING
COULD RESULT IN
SERIOUS INJURY AND/OR
PROPERTY DAMAGE.
WARNING!
DO NOT ALLOW
CHILDREN TO
ADJUST HEIGHT.
WARNING!
DO NOT LEAVE
ASSEMBLY
UNATTENDED WHEN
EMPTY; IT MAY TIP
OVER.
WARNING!
IF USING SAND:
2 GALLONS OF
ANTI-FREEZE IS
NOT REQUIRED
NOTE:
SAND SAND
(360 lb.) (360 lb.)
(163 kg) (163 kg)
522730 06/05
MOVING
SYSTEM
HEIGHT ADJUSTMENT
TO RESET OR REPOSITION BACKBOARD:
1. Grasp handle firmly and pull down to raise rim PAST highest position (above 10 feet).
2. While still holding handle firmly, CAREFULLY lower
rim to lowest position.
3. Raise to desired height by pulling down on handle.
READ BEFORE OPERATING ELEVATOR SYSTEM
CAUTION!
DO NOT LET GO OF HANDLE UNTIL THE RIM IS RESET AT LOWEST POSTION OR DESIRED HEIGHT.
FAILURE TO FOLLOW THIS
WARNING COULD RESULT
IN SERIOUS INJURY AND/OR PROPERTY DAMAGE.
1. Adjust basketball backboard height to
lowest position.
2. While holding pole,
rotate basketball
system forward until
wheels engage with
ground.
3. Move basketball
system to desired
location.
4. Carefully rotate basketball system
upright.
5. Check system for stability.
1. 3. 2.
HEIGHT ADJUSTMENT
TO RESET OR
REPOSITION
BACKBOARD:
1. Grasp handle firmly and
pull down to raise rim
PAST highest position
(above 10 feet).
2. While still holding handle
firmly, CAREFULLY lower
rim to lowest position.
3. Raise to desired height
by pulling down on
handle.