Harbor Freight Tools 42976 - Manual (Page 4)

Page 4 SKU # 42976
14. STAY ALERT. Watch what you are doing. Do not operate this machine when you are tired.
15. DO NOT OPERATE THIS MACHINE WHILE UNDER THE INFLUENCE OF ALCOHOL, DRUGS,
OR PRESCRIPTION MEDICINES.
16. CHECK FOR DAMAGED PARTS. Before using any tool, any part that appears damaged should be
carefully checked to determine that it will operate properly and perform its intended function. Check for
alignment and binding of moving parts, any broken parts or mounting fixtures, and any other condition that may
affect proper operation. Any part that is damaged should be properly repaired or replaced by a qualified
technician. Do not use the tool if any switch does not turn on and off properly.
17. REPLACEMENT PARTS AND ACCESSORIES. When servicing, use only identical replacement parts
intended for use with this tool. Replacement parts are available from Harbor Freight Tools. Use of any other
parts will void the warranty.
18. USE THE RIGHT TOOL FOR THE JOB. Do not attempt to force a small tool or attachment to do the
work of a larger industrial tool. There are certain applications for which this tool was designed. Do not modify
this tool and do not use this tool for a purpose for which it was not intended.
19. MAINTENANCE. For your own safety,maintenance should be performed regularly by a qualified
technician.
SPECIAL WARNINGS WHEN USING THIS DRILLING / MILLING MACHINE
Using this machine may create special hazards.
Take particular care to safeguard yourself and those around you.
Electrical Safety. Never operate any tool if there is an electrical hazard. Never operate an electrical
tool in wet conditions. Never operate a tool with an improper electrical cord or extension cord. Never operate
an electrical tool unless you are plugged into a properly grounded outlet, which supplies 110-120 Volts at
60 Hz. We recommend you use a circuit which is protected by an appropriate circuit breaker.
Ejected Material. Use safe practices to avoid injury from ejected material. Because milling tools and
workpieces turn at high speed, there is a danger of being injured by materials that may be ejected. Always wear
ANSI-certified eye protection. Never attempt to machine any item if it is not adequately held. Always stand to
one side of the plane in which the materials are spinning, to avoid being hit if an item is ejected. Never allow
bystanders to be in the proximity of this machine while in operation.
Entanglement. Use extreme caution to prevent loose materials from being caught in the machine.
Never operate this machine with loose clothing, long hair, jewelry, or other items which may become caught in
the tool or workpieces. In case of entanglement, press the OFF switch immediately.
NOTICE: No list of warnings can be all inclusive. The operator must supply common
sense, and operate this tool in a safe manner.