Hitachi DVP335E - Manual (Page 12)

– 12 – EN
Analog Audio out Video out
• Method 1 DVD Player + TV with Video Input Jack
• Method 2 DVD Player + TV with S-Video Input Jack
• Method 3 DVD Player + TV with 21 pin scart Jack
R L S-VIDEO IN VIDEO IN
or or
AV RGB TV
ANALOG
AUDIO OUT
L R
VIDEO
OUT
S-VIDEO
OUT
TV
Good picture Basic Audio Better picture Best picture
S-Video out EURO Audio/Video out
AV Cable S-Video
Cable
Euro
audio/video
Cable
NOTES
• If you use the Euro audio/video cable, it is not necessary to connect the analog audio cable.
• Connect the DVD player directly to a TV. If the A/V cables are connected to a VCR, pictures may be
distorted due to the copy protection system.
HOW TO CONNECT TO A TV WITHOUT AUDIO/VIDEO INPUT JACKS
If your TV does not have RCA type audio and video input jacks it is still possible to connect this DVD
player to your TV’s 75-ohm coaxial antenna terminal using a commercially available Stereo Audio/Video RF
Modulator, not included. Connect the audio and video outputs of the DVD player to the audio and video inputs on the
RF Modulator, and then connect the coaxial output of the RF Modulator (usually marked “TO TV”) to the 75 ohm
coaxial antenna terminal on your TV. Follow the instruction supplied with the RF Modulator for more details.
If your TV’s 75 ohm coaxial antenna terminal is already occupied by an antenna or cable box connection, remove that
cable from your TV’s antenna terminal and reconnect it to the coaxial antenna input terminal of the RF Modulator
(usually marked “ANT IN”), then connect the RF modulator to your TV’s antenna
terminal as described above.
NOTE
• The picture quality from DVD discs will not be as good if the DVD player is connected to the TV’s
antenna terminal through an RF Modulator.
21 pin Scart
jack
Connection to a TV (for video)
Method 1 Method 2 Method 3
CONNECTIONS
DVD