Huffy N53 W24700 - Manual (Page 5)

5
07/01 P/N 211169A printed on recycled paper
1.
Attach foam pad (22) to both front and back of backboard so that holes on pad line up with holes on backboard as
shown. Attach foam pad (23) to both Y-frame sections as shown. Lift backboard upright and insert bolt (20)
through board into Y-frame. Attach using rubber washer(21), and nut (17) as shown.
17
TWO PERSON MINIMUM
REQUIRED FOR THIS
PROCEDURE.
NOT FOLLOWING
RECOMMENDATION MAY
RESULT IN BODILY INJURY.
WARNING
20
21
21
RIM ASSEMBLY & INSTALLATION
2.
Install carriage bolt (2) through rim (1),
washers (3) and (6) as shown. Tighten
nut (4) completely. Place nut (5) about
half-way up carriage bolt (2) as shown.
1
3
2
6
4
2
5
6
22
23
Y-frame not included with this unit.
Mounting methods may vary.
NOTE