Husqvarna 966529103 - Manual (Page 7)

7
Slide the flanges of the support assembly in the 1.
slots in the drawbar.
2
BAGGER SUPPORT ASSEMBLY
Pivot the assembly backwards to insert the bottom 2.
pin into the drawbar. Secure the bottom pin with a
hairpin.
ASSEMBLY
Support
Assembly
Hairpin
8063-086
8063-085
3
MOUNTING BLOWER ASSEMBLY
Remove the discharge chute from the deck. 1.
Lower deck to the lowest cutting position. 2.
Remove the right hand (discharge side) belt cover 3.
from the deck.
Position blower over the discharge tabs on the
4.
deck and set blower onto the deck.
Be sure the blower is sitting flush against the
5.
outside of the deck.
Install the front mount bracket to the deck with the 6.
pin and hairpin cotter supplied with the kit.
Rear Mount Bracket
Contact Area
8063-072
Outer Pulley
Cover
Pin
Hairpin Cotter
8063-073
Locate the rear adjustment nut on the discharge 1.
side of the deck. To assure the right tighteness,
mark the front side of the nut.
Using the mark as a guide, turn the nut clockwise
2.
five turns with a ¾" wrench.
1
DECK ADJUSTMENT