Husqvarna 966529103 - Manual (Page 10)

10
CAUTION
DO NOT operate mower with grass catcher •
partially installed.
Disengage blades and stop engine before
•
leaving mower seat to empty containers,
unclogging chutes, etc.
Close cover before starting.
•
Disengage mower blades when crossing •
driveways or gravel surfaces and other
areas where thrown objects could be a
hazard.
DO NOT attempt to vacuum cans or other
•
potentially hazardous projectiles.
CAUTION
Grass catcher components are subject to
wear, damage and deterioration, which could
expose moving parts or allow objects to be
thrown. Frequently check components and
replace with manufacturer’s recommended
parts, when necessary.
CAUTION
BEFORE PERFORMING MAINTENANCE,
SERVICE OR ADJUSTMENTS:
Set parking brake. •
Place motion control levers in “NEUTRAL” •
position.
Place clutch control in “DISENGAGED”
•
position.
Turn ignition key to “OFF” position.
•
Make sure blades and all moving parts •
have completely stopped.
Disconnect spark plug wire(s) from spark
•
plug(s) and place wire where it cannot
come in contact with plug.
ASSEMBLY
Rotate the chute so the opening is facing downwards
toward the container bags.
8063-091
12
CHUTE/HOOD INSTALLATION
Install containers on support frame, overlapping 1.
containers at center tube.
Note: One container should always overlap the
other container at the center tube.
Close cover and lock latch handle over support
2.
tubes.
11
CONTAINER INSTALLATION
8063-093