Henkel 9000 - Manual (Page 9)

Maintenance 6
Routine
1. Inspect air tubing, product tubing, and fittings for cracks, kinks or breaks and replace, as
required.
2. Drain the air line filter bowl, if necessary.
Idle Time
1. If the pump is in daily use, you do not need to service the pump or product tubing to prevent
product curing unless a contaminant is introduced into the system.
2. The pump and tubing can be left idle for as long as one (1) month without curing under normal
temperature (70° - 80°F).
3. If the pump is to be idle for longer than one (1) month, both the pump and the product lines
should be serviced. Remove and replace product feed lines. Return the pump to a Loctite
Service Center for cleaning and/or rebuilding.
4. If a gravity feed reservoir is being used, refer to the reservoir manual for idle time information.
8