Harbor Freight Tools 98194 - Manual (Page 9)

Page 9 For technical questions, please call 1-800-444-3353. SKU 98194
SpeCiFiCationS
Motor
120 V~ / 60 Hz / 15 A
n
0
4300/min
Blade 12” Diameter, 1” Arbor
Cutting Capacity
At 90°: 4” D x 12-3/16” W
At 45°: 2-1/8” D x 8-1/4” W
Positive Table Stops 0°, 15°, 22.5°, 30° and 45° both
Right and Left
Positive Bevel Stops 0° and 45° Left only
Blade Tilt Range
0° - 45° right and left miter
0° - 45° Left
Laser Power Supply 2 ‘AAA‘ batteries
Laser Light
Do not stare into beam
max. output: <1mW,
Wavelength: 654 nm
Class II laser ProduCt
this product complies with
21 CFr 1040.10 and 1040.11
CeN-teCH
3491 Mission oaks Blvd.,
Camarillo, Ca, usa, 93011
Manufacture date: ___________, _______
Caution: Use of controls or adjustments
or performance of procedures other
than those specified herein may result in
hazardous radiation exposure.
Caution: The use of optical instruments
with this product will increase eye
hazard.
unpaCking
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at 1-800-444-3353 as soon as
possible.
list of contents
description Qty
Compound Sliding Miter Saw 1
12” Carbide Tipped Blade 1
Table Extensions 2
Dust Collection Bag 1
Wrench 1
initial Set up inStruCtionS
read the entire important
SaFetY inFormation section at
the beginning of this manual
including all text under
subheadings therein before set up
or use of this product.
to preVent
SeriouS injurY
From aCCidental
operation:
turn the power Switch of the tool
to its “oFF” position and unplug
the tool from its electrical outlet
before assembling or making any
adjustments to the tool.
note: For additional information regarding the
parts listed in the following pages, refer
to the Assembly Diagram near the end of
this manual.
assembly
attaching the extension Supports
Insert the ends of the Extension
Supports into the holes in the sides of
the Base. Tighten the Wing Screws to
hold the Extensions in place. The upper
edge of the Extensions will be level with
the surface of the saw. This provides a
wider base for the work material to rest
on.
attaching the dust Collection bag
The Dust Collection Bag slips over the
Dust Outlet behind the Blade Housing
Assembly. Sawdust created by cutting is
captured in the bag.
mounting the Saw
The Miter Saw must be mounted on
a support before use. This may be a
warning
reV 08k, 09a, 09j