Lamp replacement – Hitachi 42V515 User Manual

Page 69

LAMP REPLACEMENT

Without installing the lamp cover, the power will be off and the Lamp Indicator will flash (see page 8). Be sure to install the lamp
cover by re-engaging the two clips and tighten the screws before turning the power on, otherwise it may cause unusual colors.

SCREW

LAMP COVER

PHILLIP HEAD

SCREW DRIVER

NOTE:

IF POWER IS CONNECTED BEFORE THE LAMP COVER IS INSTALLED, THE POWER WILL
BE OFF AND THE LAMP INDICATOR WILL FLASH (SEE PAGE 8 ).

Install the front cover as shown below. Put the front cover back in and align the snap on quick connect then push inwards hold-
ing the left and right side of the front cover until you hear a snap. Push the other snap on gently to make a good fit.

Plug power cord into AC outlet and turn on the main power switch.

120V

NOTE: This product contains lead and a lamp that contains mercury. Dispose of this product and its lamp in accordance with

applicable environmental laws. For lamp recycling and disposal information, go to www.lamprecycle.org. For product
recycling and disposal information, contact your local government agency or the Electronic Industries Alliance at
www.eiae.org (in the US) or the Electronic Product Stewardship Canada at www.epsc.ca (in Canada).
For more information, call “1-800-HITACHI.”

LAMP

REPLACEMENT