The tanks – Hoover 500 User Manual

Page 9

To remove tank, squeeze release button

and pull tank straight out.

Carry tank to a sink.

Rotate tank cap counter-clockwise and

lift up to remove cap (A).

Turn cap (A) upside down to serve as a measuring

cup.

For hard surface floors such as vinyl, linoleum, marble,

laminate wood, polyurethane sealed wood or other wood
floors that can normally be cleaned using water

, use one

cup (2 oz.) HOOVER® Floor to Floor™ Cleaner.

Check for worn spots or joint separations before using,
as these conditions could lead to damaged flooring when
using water to clean floor.

When cleaning ceramic and other tiles

, use the set of

grout brushes with gray bristles included with your

FloorMate™ SpinScrub™ 500 Cleaner. Use these for tile

floors where extra attention is needed for cleaning grout.

(See “Cleaning the brushes” section for how to remove

and replace the brush assemblies.)

Using cup, measure 1-1/2 cupfuls (3 oz.) of HOOVER®

Grout Cleaner.

Solution (upper) tank

The solution tank holds detergent and water that is to be dispersed onto the

surface being cleaned.

How to fill

Disconnect cleaner from electrical outlet.

Place cleaner handle in upright, locked position.

The tanks

Continued ➜