Harbor Freight Tools 93119 - Manual (Page 3)

Page 3 SKU 93119 For technical questions, please call 1-800-444-3353.
air passages. Wear an ANSI-approved dust mask or respirator when working around
chemical mist.
do not overreach. Keep proper footing and balance at all times. Do not reach over or
across running machines.
Maintain tools with care. Keep tools clean for better and safer performance. Follow
instructions for lubricating and changing accessories. Inspect tool hoses periodically
and, if damaged, have them repaired by an authorized technician. The handle must be
kept clean, dry, and free from oil and grease at all times.
disconnect power. Unplug compressor when not in use.
Remove adjusting keys and wrenches. Check that keys and adjusting wrenches are
removed from the tool or machine work surface before plugging it in.
Avoid unintentional starting. Do not carry any tool with your finger on the trigger,
whether it is plugged in or not.
Stay alert. Watch what you are doing. Use common sense. Do not operate any tool
when you are tired.
Check for damaged parts. Before using any tool, any part that appears damaged
should be carefully checked to determine that it will operate properly and perform its
intended function. Check for alignment and binding of moving parts; any broken parts
or mounting fixtures; and any other condition that may affect proper operation. Any part
that is damaged should be properly repaired or replaced by a qualified technician. Do
not use the tool if any valve does not operate properly.
Replacement parts and accessories. When servicing, use only identical replacement
parts. Use of any other parts will void the warranty. Only use accessories intended for
use with this tool. Approved accessories are available from Harbor Freight Tools.
do not operate tool if under the influence of alcohol or drugs. Read warning labels
on prescriptions to determine if your judgment or reflexes are impaired while taking drugs.
If there is any doubt, do not operate the tool.
do not spray near open flames, pilot lights or heaters, or any other heat source.
Most solvents and coatings are highly flammable, particularly when sprayed. Always
make sure that the work area is well ventilated.
do not smoke while working with spraying tools. Do not spray in an area where lit
cigarettes or cigars are present.
Extinguish all smoking materials before using or clean-
ing the spray tool.
do not use air pressure loads which exceed the working pressure (60 PSI). Ex-
ceeding the working pressure will cause the safety valve to release air, if it is working
properly, in order to prevent the tank from exceeding it’s maximum pressure. Exceeding
the Tank’s maximum pressure can cause the pressure pot to rupture or explode.
during each use, pull the ring on the safety valve to check that it operates freely
and relieves air pressure. If the safety valve is stuck, does not operate freely, or does
not relieve air pressure, replace the valve.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
20.
21.
REV 06/06