haier AS072AZNBA - Manual (Page 10)

Operation
8
COOL and DRY operation
AUTO DRY FAN COOL
AUTO
AUTO LO MED HI
(1) Unit start
(2) Select operation mode
(3) Select temp. setting
Press MODE button. For each press, operation
mode changes as follows:
Unit will run in operation mode displayed on LCD.
Stop display at your desired mode.
Press FAN button. For each press, fan speed changes
as follows:
Hints
(4) Fan speed selection
Unit will start running to reach the temp. setting on LCD.
Recommendations:
Use COOL in summer.
Use DRY in spring, autumn and in damp climate.
Press ON/OFF button, unit starts.
Previous operation status appears on display. (Not Timer setting)
Power indicator on indoor unit lights up.
Press TEMP. button.
Every time the button is pressed, temp. setting increases 1
o C
Every time the button is pressed, temp. setting decreases 1 o C
Unit runs at the speed displayed on LCD.
In DRY mode, when room temp. becomes 2
o C higher than
temp. setting, unit will run intermittently at LO speed
regardless of FAN setting.
Remote controller can memorize each operation status. When starting it next time,
just press ON/OFF button and unit will run in previous status.
COOL operation starts when room
temp. is higher than temp. setting.
Temp. setting
Temp. setting+2 o C
Ultra-low air flow
On reaching temp. setting,unit
will run in mild DRY mode.
LOCK
RESET CODE
MODE SLEEP
CLOCK SET
TIMER
A
SWING FAN
TEMP
ON
OFF
3
1
2
5 6
4