Transom angle adjustment, Installation – HONDA BF20D User Manual
Page 38
36
TRANSOM ANGLE
ADJUSTMENT
(types without clamp screws)
INSTALLATION
LOCK NUT
WASHER
LOCK NUT
TRANSOM
BOARD
WASHER
MOUNTING
HOLE
WASHER
BOLTS
CARRYING
HANDLE
(Storage position)
Use the transom angle adjustment rod
(p.
) to adjust the angle of the
outboard motor so the propeller is
perpendicular to the surface of the
water.
Attach the stern bracket to the boat
transom with good quality stainless
steel bolts, nuts, and washers. Apply
silicone sealant to the bolts holes.
You may further secure the outboard
motor by bolting the stern bracket to
the boat transom. Use the optional
mounting bolt and nut kit or other
good quality stainless steel bolts, nuts,
and washers. Apply silicone sealant
to the bolt holes.
Attach a rope from the boat to the
hole in the stern bracket. This will
help to prevent accidental loss of the
outboard motor.
Attach the stern bracket to the
transom and tighten the clamp screws.
Push the carrying handle into the
storage position.
07/09/19 18:22:17 31ZY0600_037