Harbor Freight Tools 5.5 HP ENGINE 96156 - Manual (Page 11)

Page 11 For technical questions, please call 1-800-444-3353. SKU 96156
servIcInG
to Prevent
serIous InjurY
FroM accIdentaL startInG:
close the engine’s fuel valve,
wait for the engine to cool, and
disconnect the spark plug wire(s)
before performing any
inspection, maintenance, or
cleaning procedures.
to Prevent
serIous InjurY
FroM enGIne FaILure:
do not use damaged engine. If
abnormal noise, vibration, or
excess smoking occurs, have the
problem corrected before further
use.
Maintenance Procedures
Many maintenance procedures,
including those not detailed in this
manual, will need to be performed
by a qualified technician for safety.
If you have any doubts about your
ability to safely service the engine,
have a qualified technician service
the engine instead.
note: Warranty is void if proper maintenance
and servicing procedures are not
followed.
engine oil change
cautIon! Oil is very hot during operation
and can cause burns. Wait for engine to
cool before changing oil.
drain
Plug
1. Place a drain pan (not included)
underneath the crankcase’s drain plug.
Remove the drain plug and, if possible, 2.
tilt the crankcase slightly to help drain
the oil out. Recycle used oil.
Replace the drain plug (and gasket, if 3.
supplied) and tighten it.
Refill the oil to the proper level following
4.
the instructions under the Starting the
Engine section.
air Filter element Maintenance
Wipe off the air cleaner cover. 1.
The air cleaner cover is held in place by 2.
two knobs. Remove them.
Remove the air filter element.
3.
Wash the element in warm water and 4.
mild detergent several times. Rinse.
Squeeze out excess water and allow
it to dry completely. Soak the filter in
lightweight oil briefly, then squeeze out
the excess oil.
Install the new filter or the cleaned filter.
5.
Secure the Air Cleaner Cover before
use.