To connect the cradle, Using your handheld with another pim – Handspring Visor User Manual
Page 32
Page 32
Introduction to Your Visor™ Handheld
To connect the cradle:
1. Plug the cable from the handheld cradle into the USB port or serial
port on your computer.
Note: If you are unsure about the exact location of the USB port or
serial port on your computer, refer to the manual supplied
with the computer.
Using your handheld with another PIM
If you prefer to use another personal information manager (PIM), you
can use it if third-party connection software, called a conduit, is
available for your PIM. You must install the software that came with
your Visor handheld along with the conduit for your PIM to
synchronize the data between your handheld and your PIM. For
information on conduit software, go to this web site:
www.handspring.com.
Shown with
USB port
Shown with
Serial port