haier slim3 - Manual (Page 19)

Front Load Washing Machine Model:slim3
16
Error message :The heater may be broken
Troubleshooting:
N
Y
Y
Cut off power ,check the resistance
Of two pins of heater element by
multimenter is it between 32-35
Ω ?
Turn on power ,and set wash
mode,then start ,check the export
voltage of heater element between
12-6 and J9-9 ,is it between AC
220-240V?
Heater element
must be broken
please replace
it
PCB must be
broken, please
replace it
Error message:The required water level is not reached within 8 min.
Troubleshooting:
N
Check if inlet valve is jammed
Clean inlet valve
N
Y
N
N
Check if water is leaking from washer
bottom. inlet pipe. drain pipe or other
pipe connection
Check if tap is closed or water pressure is too
low (usual between0.2 -1 MPa)
Observe if the height of
drain pipe not reach 80
cm. If water level
pressures switch and
the hose is leaking gas
Y
Draw out the dispenser and check if water is
entering
Readjust or replace the broken parts
Y
Open the tap or wait for normal water pressure to use
Y