Harbor Freight Tools 07528 - Manual (Page 4)

SKU 07528 Page 4
20. Check for damaged parts. Before using any tool, any part that appears
damaged should be carefully checked to determine that it will operate
properly and perform its intended function. Check for alignment and binding
of moving parts; any broken parts or mounting fixtures; and any other
condition that may affect proper operation. Any part that is damaged should
be properly repaired or replaced by a qualified technician. Do not use the tool
if any switch does not turn On and Off properly.
21. Do not operate tool if under the influence of alcohol or drugs. Read
warning labels on prescriptions to determine if your judgment or reflexes are
impaired while taking drugs. If there is any doubt, do not operate the tool.
Warning: The warnings, cautions, and instructions discussed in this instruc-
tion manual cannot cover all possible conditions and situations that may oc-
cur. It must be understood by the operator that common sense and caution
are factors which cannot be built into this product, but must be supplied by
the operator.
Warning: The brass components of this product contain lead, a chemical known
to the State of California to cause birth defects (or other reproductive harm).
(California Health & Safety Code 25249.5 et seq.)
Unpacking
When unpacking, check to make sure that the following parts are included. If any
parts are missing or broken, please call Harbor Freight Tools at the number on the
cover of this manual as soon as possible.
Assembly
Air Connection
2. Attach the Air Quick Coupler (not supplied) to the Air Inlet (13) fitting.
1. If desired, for easy connection or removal, attach an Air Quick Coupler (not
supplied) to the air compressor hose.
3. Tighten all couplings and fittings. See photos on the next page.
(34)
(35)
(36)
1/2 Inch Air Drill