Hotpoint GF941 - Manual (Page 7)

7
How To Use Your Hob
The position of the corresponding gas burner is indicated on
each control knob.
Gas Burners
The burners differ in size and power. Choose the most
appropriate one for the diameter of the cookware being used.
The burner can be regulated with the corresonding control
knob by using one of the following settings:
• Off
High
Low
On those models fitted with an ignitor (D),
To light a burner, simply press the corresponding knob all
the way in and then turn it in the counter-clockwise direction
to the "High" setting, keeping it pressed in until the burner
lights.
As they are fitted with a flame failure device (F), the
knob must be pressed in for about 6 seconds until the device
that keeps the flame lighted warms up.
Caution: If the burner accidently goes out, turn off the gas
with the control knob and try to light it again after waiting at
least 1 minute.
To turn off a burner, turn the knob in the clockwise direction
until it stops (it should be on the “•” setting).
Griddle (model GF941B only)
The griddle can be regulated by turning the corresponding knob
in the clockwise or counter-clockwise direction to any of the 12
possible settings:
0 Off
1 Low
2-11 Medium
12
High
When the knob is on any of the settings other than "Off", the
"H" operating light comes on.
Ceramic Glass Module (model GF941V)
This cooktop is fitted with dual-ring radiant heating elements
located beneath the glass. It is possible to turn on only the
circular part of the elemement (identified by the letter "A") or the
cooking surface can be enlarged by turning on both "A" and
"B". To turn only the circular "A" element, simply turn the knob in
the clockwise direction to any one of the 12 available settings.
To add the "B" section, turn the knob to setting 12 and then click
it into the
setting. Then proceed by turning the knob in the
counter-clockwise direction to one of the 12 settings.
The figure shows the heating zones, which become red when
the element is turned on.
A. Circular heating zone;
B. Extended heating zone;
C. Indicator light to show when the cooking zone is above
60°C, even after the heating element has been turned off.
A
C
B
When the knob is on any of the settings other than "Off", the
"H" operating light comes on.