Hotpoint GF941 - Manual (Page 13)

1 3
Installation
Hook position for Hook position for
H=30mm top H=40mm top
Front
Hook position for Back
H=20mm top
N.B: Use the hook contained in the "accessoires set"
f) In the event the hob is not installed above a built-in oven,
a wood panel must be inserted as insulation. This panel
must be placed at least 20 mm from the bottom of the
hob itself.
Important: When installing the hob above a built-in oven,
the oven should be placed on two wooden strips; in the
case of a joining cabinet surface, remember to leave a space
of at least 45 x 560 mm at the back.
560 mm.
45 mm.
When installing on a built-in oven without forced ventilation,
ensure that there are air inlets and outlets for ventilating the
interior of the cabinet adequately.
Gas connection for gas hob
The hob should be connected to the gas-supply by a corgi
registered installer. During installation of this product it is
essential to fit an approved gas tap to isolate the supply
from the appliance for the convenience of any subsequent
removal or servicing. Connection of the appliance to the gas
mains or liquid gas must be carried out according to the
prescribed regulation in force, and only after it is ascertained
that it is adaptable to the type of gas to be used. If not,
follow the instructions indicated in the paragraph headed
“Adaptation to different gas types”. In the case of connection
to liquid gas, by tank, use pressure regulators that conform
to the regulation in force.
Important: For safety, for the correct regulation of gas use
and long life of the appliance, ensure that the gas pressure
conforms to the indications given in table 1 “Nozzle and burner
characteristics”.
Connection to non-flexible tube
(copper or steel)
Connection to the gas source must be done in such a way
as to not create any stress points at any part of the
appliance.
The appliance is fitted with an adjustable, "L" shaped connector
and a gasket for the attachment to the gas supply. Should this
connector have to be turned, the gasket must be replaced
(supplied with the appliance).
The feeding connector of the gas to the appliance is threaded
1/2 gas male cylinder.
Connection to flexible steel tube
The gas feed connector to the appliance is a threaded, male
1/2" connector for round gas pipe. Only use pipes and sealing
gaskets that that conform to the standards currently in force.
The maximum length of the flexible pipes must not exceed
2000 mm. Once the connection has been made, ensure
that the flexible metal tube does not touch any moving parts
and is not crushed.
Check the Seal
Once the hob has been installed, make sure all the
connections are properly sealed, using a soapy water
solution. Never use a flame.