HP Compaq TFT 2025 - Manual (Page 11)

2025 Flat Panel Display
User’s Guide 7
Removing the Monitor Base
Before you can mount the monitor onto a swing arm or other
mounting fixture, you must remove the monitor from the base.
Ä CAUTION: Before beginning to disassemble the monitor, be sure
the monitor is turned off and the power and signal cables are both
disconnected.
To remove the monitor from the base:
Ä CAUTION: Lay the front bezel down on a soft area to prevent it from
getting scratched, defaced, or broken.
Å WARNING: Before removing the monitor from the base, ensure that
the monitor is lying flat, front bezel down, and that the base is set to
the maximum base extension. Attempting to remove the monitor from
the base while upright in the minimum base extension may result in
injury to the user.
1. Disconnect and remove the signal and power cables from the
back of the monitor.
305495-001.book Page 7 Tuesday, August 20, 2002 8:21 AM