Installation, Siting, Moving the cooker – Hotpoint H050E User Manual

Page 20

Installation

(6")
150mm
MIN.

500mm
(20")

500mm (MIN)

APPLIANCE

Note: Take care when moving the cooker as it is heavy. Take care to ensure that any

floor covering is not damaged.

Note: The appliance should NOT be placed on a base.

SITING

The cooker is designed to fit between kitchen cabinets spaced 500mm apart
minimum. The space either side need only be sufficient to allow withdrawal of
the cooker for servicing. It can be used with cabinets one side or both as well as
in an angled corner setting. It can also be used free-standing.

Adjacent side walls which project above hob level, should be protected by heat
resistant material, but in any case should not be nearer to the cooker than
150mm. Any overhanging surface should not be nearer than 500mm.

Excess steam from the oven is expelled at the rear of the cooker, therefore the
wall behind the cooker needs to be protected against grease and moisture.

MOVING THE COOKER

Before moving your cooker ensure that it is cool and note that it is heavy.
Movement of your cooker is most easily achieved by lifting the front as follows:
Open the oven door sufficiently to allow a comfortable grip on the underside
front edge of the oven roof.