Hotpoint SY23 - Manual (Page 12)

BEFORE USING THE OVEN
These instructions are only valid for the destination countries whose identification
symbols are shown on the back cover of the appliance instruction booklet.
To make the most of your new oven, read the users instructions carefully and keep
them on hand for consulting in the future.
Remove the cardboard protection and the protective plastic film.
Remove the accessories from the oven and heat it at the maximum temperature setting
for about 30 minutes to eliminate the bad smell of protective grease and insulating
materials. Keep the window open during this operation.
Make sure that the electrical wires of other electrical appliances near the cooktop or
the oven do not come into contact with hot parts and do not become entrapped in
the oven door.
Your oven is equipped with a fan designed to cool internal parts of the cabinet and
the oven components. The fan creates a gentle flow of air, which comes out the
steam vent located below the control panel. The cooling system starts working
immediately while it can stop immediately after the oven is switched off or from
10 to 30 minutes later (depending on the oven temperatures). In the event of
malfunction of the cooling fan, do not use the oven. Contact the after-sales Service.
In case of interruption of the electricity supply, do not use the appliance;
if it happens during the use of the appliance, switch off the appliance and do not use it.
It is possible for the inside of the glass in the oven door to cloud up during cooking.
Do not rest heavy weights on the door because these could damage the oven cavity
and the hinges.
Do not obstruct cooling openings or slots or the fume exhaust.
If turning the oven burner knob becomes difficult, contact the After Sales Service
for replacement.
GB
11