Hotpoint HCM60 - Manual (Page 11)

AMC-3
Fig. 4
FILLING THE WATER TANK AND COFFEE BEAN HOLDER
Filling the water tank
The water tank should only be filled once it has been taken out of the machine.
For a good espresso coffee, as well as using quality coffee, good water should also be used. It is therefore recommended
that you empty the water tank frequently, preferably daily, and refill it with fresh water. Avoid leaving the water for too long
time in the water tank.
Boiling water or other liquids may damage the coffee machine. Fill the water container daily with just cold or running
drinking water.
• Open the machine by lifting the handle and then pulling outwards.
• Take the lid off the water tank.
• Remove the tank and fill it with fresh water up to 4 cm from the top.
• Place the tank in the machine and replace the lid.
• Close the machine.
N.B. The machine has an LED to the left of the buttons ( ), that indicates when there is little water left and that it is time
to refill the tank.
Filling the coffee bean container
Only fill the coffee bean container with beans for espresso coffee.
Any other substance, including ground coffee, will damage the coffee machine.
The coffee machine should not be filled with beans treated with caramel, sugar or other similar substances,
instant coffee or drinks containing sugar. Sugar can damage the machine.
The coffee bean container cannot be removed for technical reasons.
• Open the machine by lifting the handle and then pulling outwards.
• Take the lid off the coffee bean container.
• Fill the coffee bean container with coffee beans up to 2 cm from the top.
• Replace the lid on the container.
• Close the machine.
N.B. The machine has an LED to the left of the buttons ( ), that indicates when there is little coffee left and that it is time
to fill the container.
ON/O FF ON/O FF
C
C