Harbor Freight Tools BACKPACK SPRAYER 94573 - Manual (Page 9)

Page 9 For technical questions, please call 1-800-444-3353. SKU 94573
InSPECTIOn, MAInTEnAnCE,
And CLEAnInG
CAuTIOn! Make sure the Power Switch
(58) is in its “OFF” position and
unplugged from its Charger (63).
Then, de-pressurize the system
before performing any inspection,
maintenance, or cleaning of the
Sprayer.
Before each use,
1. inspect the general
condition of the Sprayer. Check for
misalignment or binding of moving parts,
damaged or loose parts, dirt or debris in
the Filter and Nozzle, damaged electrical
wiring, and any other condition that
may affect the tool’s safe operation. If
abnormal noise or vibration occurs, have
the problem corrected before further use.
do not use damaged equipment.
To clean: 2. If using liquid chemicals,
flush the interior and clean the exterior
of the Sprayer and its Spray Gun
Assembly thoroughly with cleaning
agents recommended by the chemical
manufacturer. Then, allow to air-dry. Do
not use solvents.
When storing:
3. Always completely
empty the Sprayer of liquid. Frost will
damage the Sprayer if the unit contains
liquid. Store the Sprayer in an indoor
area such as a garage or shed. Make
sure to store the Sprayer and any
chemicals in a safe, dry, clean
location out of reach of children and
other unauthorized people.
CAuTIOn!
4. All maintenance, service,
and repairs not discussed in this manual
should only be performed by a qualified
service technician.
TROuBLEShOOTInG
Problem Possible Solution
Unit does not spray. Fully charge the battery. 1.
Fill the tank. 2.
Firmly tighten the Tank Cap and secure all connections on the tank and 3.
the spray gun assembly.
Clear the Nozzle on the Spray Gun assembly of dirt and debris.
4.
The spray pattern is
undesirable.
Use the proper Nozzle for the job at hand. 1.
Clear the Nozzle on the Spray Gun assembly of dirt and debris. 2.
PLEASE REAd ThE FOLLOWInG CAREFuLLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND
ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE
MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY
OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS
OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY
STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN
BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER
ASSUMES ALL RISKS AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS
OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.