Electrolux U20011 ER 6624 - Manual (Page 17)

Door Reversal
Before carrying out the operations described below,
pull out the mains plug from the wall socket.
steps:
Carry out door reversal as follows:
1. Gently lay the appliance on its back with the top
held away from the floor by 5-8 cm (2-3 inches)
of packing.
2. Remove the bottom door hinge (5).
3. Remove the door (4) by opening it and pulling it
gently downwards to remove it from the top hinge
pin (2).
4. Unscrew the top hinge pin (2) from the top hinge
(1) and replace it in the opposite hole on the left
hand side.
5. Unscrew the foot at the base (6) of the appliance
and refit it on the opposite side.
6. Refit the door and the bottom hinge to the left
hand side.
7. Remove the door handle (3) and fit it on the
opposite side after having pierced the plastic
plugs with a punch. Cover the holes left open
with the plugs contained in the documentation
pack.
When the bottom hinge is screwed in, a certain
amount of force is exerted on the screws.
It is therefore advisable to lubricate the screw
tips before starting this operation.
Important
After completion of the door reversal opera-
tion, verify that the door gasket is sealing
onto the cabinet.
17