Electrolux 1261 - Manual (Page 46)

46
If you intend the drain hose from the machine
to empty into a sink, make sure that the sink
is empty and the plug hole is not blocked. Use
the plastic “U -Piece” supplied.
Important
Before connecting up the machine to new
pipework or to pipework that has not been used
for some time, run off a reasonable amount of
water to flush out any debris that may have collected in the pipes.
In the interest of the environment
Washing machines and dish-
washers should be connected
to the FOUL drainage system,
the water will then be taken
to a sewage works for treat-
ment before being discharged
safely into a river.
It is essential that these appli-
ances are not connected to the
surface water drainage system
as this water is discharged
directly into a river or stream
and may cause pollution.
If you require any further
advice please contact your local
authority drainage department.
Electrical connections
WARNING: THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability should this safety measure
not be observed.
If the plug that is fitted to your appliance is not suitable for your socket
outlet, it must be cut off and the appropriate plug fitted.
Remove the fuse from the cut off plug.
The cut off plug should then be disposed of to prevent the hazard of
shocks in case it should be plugged into a 13 Amp socket in another
part of your home.
Installation
SHOWER
BATH
SINK TOILET
BIDET
WASHING
MACHINE
DISHWASHER
RAINWATER
'RUN-OFF'
SURFACE WATER
DRAINS & SEWERS
UNTREATED
DISCHARGE
RIVER
FOUL DRAIN
FOUL SEWERS
SEWAGE
TREATMENT
WORKS
RIVER
TREATED
DISCHARGE
RAINWATER
'RUN-OFF'
SURFACE WATER
DRAINS & SEWERS