EnGenius Technologies 1X - Manual (Page 13)

~25~
handset responds.
4. Before a handset answers, the INTERCOM can be cancelled from the
base by pressing INTERCOM again. However, once a handset answers,
only the answering handset can end the call.
C. Intercom/2-Way from Handset to Base
1. Press Intercom key followed by a two-digit base ID
[Note: Base 1 ID as 10, Base 2 ID as 20, Base 3 ID
as 30, and Base 4 ID as 40]
2. The base will ring once, then automatically connect
the intercom call from a handset.
Making a Broadcast
A. Handset to Handset Calls
1. Broadcasting
all handsets
a. Press “BROADCAST” key from one handset
b. Hear bi-bi-beep while the initiating handset
broadcast all handsets within communication
coverage
c. Start to speak the message to be broadcasted
once you hear the “beep” sound; the
speakerphone of destination handsets will be
opened up
d. Press END key to end the broadcasting
2. Broadcasting a group of handsets
a. Enter the Group ID and then press
“BROADCAST” key
b. Hear bi-bi-beep while the initiating handset
broadcast all handsets within communication
coverage
c. Start to speak the message to be broadcasted
once you hear the “beep” sound; the
speakerphone of destination handsets will be
opened up
d. Press END key to end the broadcasting
3. Broadcasting an individual handset
a. Enter the Handset ID and then press
­ 11
Please enter
Ext. #: 10
­ 11
PA paging
to all…
­ 11
PA paging
to Ext. # 02
~26~
“BROADCAST” key
b. Hear bi-bi-beep while the initiating handset
broadcast all handsets within communication
coverage
c. Start to speak the message to be broadcasted
once you hear the “beep” sound; the
speakerphone of destination handsets will be
opened up
d. Press END key to end the broadcasting
B. Broadcasting from Base to Handset
1. Broadcast to all handsets
a. Press Broadcast key on the base station to
intercom all registered handsets.
b. Hear bi-bi-beep while the initiating handset
broadcast all handsets within communication
coverage.
c. The Broadcast LED will light up
d. Press the Broadcast key again and return to
IDLE mode
C. Broadcasting from Handset to Base
1. Broadcast to the base station
a. Enter the Base ID and then press
“BROADCAST” key
b. Hear bi-bi-beep while the initiating handset
broadcast the base stations.
c. Start to speak the message to be broadcasted
once you hear the “beep” sound; the
speakerphone of the base will be opened up
d. Press the END key again and return to IDLE
mode
Redial
1. Press REDIAL (Left) soft key.
2. The LCD shows the last phone number dialed. To dial this number,
press
DIAL (Left) soft key.
3. Use Up or Down Arrow Key to scroll through the last 10 phone numbers
dialed. Select and press
DIAL key.
­ 11
PA paging
to Ext. # 12
­ 11
PA paging from
Base 1
SLIENT
­ 11
PA paging
to Ext. # 10