Electrolux CSIG 511 - Manual (Page 37)

If the ignition system doesn't work there may be a fault with the
electrical supply. First, check the socket by trying out another piece of
electrical equipment in it, if that works correctly renew the fuse in the
plug.
If the fuse keeps failing there is a fault in the appliance which must
be put right. Do not use a fuse with a rating higher than 3 amps. Do not
carry out other electrical work. Unplug the appliance and tell your
installer.
Replacing the oven light bulb
You need a 25 Watt small Edison screw with a temperature rating of
T300.
l
Make sure the oven is cool before you replace a bulb.
l
Unplug the appliance.
l
Open the oven door and remove the oven shelves.
l
Place palm of hand at top of lens flat against oven side. Use fingers
to lever lens away from housing.
l
Unscrew the bulb by turning it to the left.
l
Fit a new bulb and then replace the glass bulb cover.
l
Replace the oven shelves.
l
Plug the appliance back into the electricity supply.
The oven light bulb is not covered by the manufacturers guarantee.
37
C S I G 5 1 1
General information