How to use, Fig. 6 fig. 7 fig. 8 fig. 9 – Eureka 3670 SERIES User Manual
Page 10
ENGLISH
HOW TO USE
CAUTION: Do not plug in cleaner until you
understand all controls and features.
To Clean Bare Floors and Rugs
Step 1: Attach wands to hose handle.
Step 2: Place floor tool on end of wand.
Step 3: For models with telescopic wands, extend wands
by pushing lock button down and pulling on lower
wand until reaching desired height (Fig. 6).
Step 4: Adjust to maximum suction by closing the slip ring
●
K
on the hose handle (Fig. 6).
Step 5: Rotate swivel cord hook
●
L
on bottom of canister
to release cord (Fig. 7).
Step 6: Plug cord into appropriate outlet.
Step 7: Push on/off switch
●
M
. Press once to turn on.
Press again to turn off (Fig. 8).
To Clean Stairs, Upholstery and
Window Treatments
(see pages 6-7 for accessory details)
Step 1: Attach combination tool, crevice tool or turbo
nozzle (on some models only) to the end of the
hose. If additional reach is needed place wand on
hose handle first.
Step 2: Adjust to minimum suction by opening the slip ring
●
K
on the hose handle (Fig. 6).
Step 3: Rotate swivel cord hook
●
L
on bottom of canister
to release cord (Fig. 7).
Step 4: Plug cord into an appropriate outlet.
Step 5: Push on/off switch
●
M
. Press once to turn on.
Press again to turn off (Fig. 8).
To Use Blower Port
Step 1: Remove HEPA filter (on some models only). See
pages 14-15 for details.
Step 2: Detach hose
●
B
from front of canister
●
A
and
attach to the blower port
●
J
on the back side of
the canister (Fig. 9).
Step 3: Rotate swivel cord hook
●
L
on bottom of canister
to release cord (Fig. 7).
Step 4: Plug cord into appropriate outlet.
Step 5: Push on/off switch
●
M
. Press once to turn on.
Press again to turn off (Fig. 8).
FIG. 6
FIG. 7
FIG. 8
FIG. 9
10
●
K
●
L
●
M
●
B
●
A
●
J