Ericsson LBI-38732E - Manual (Page 86)

To view the currently selected status after it has been
transmitted, press the
7
key and then the CLEAR
button prior to the time-out period. If the status was not
sent successfully to the site, the text associated with the
status will flash in the display.
The radio can also be pre-programmed to redesig-
nate the keypad buttons for ST0 thru ST9 to send status
condition. In this configuration the radio status operation
will operate as previously described except the
7
key is not required.
Message Operation
Message operation permits the transmission of a
pre-programmed message text to an EDACS site.
To send a message, press the
8
key then press
one of the number keys ( 0 - 9 ) to select the
pre-programmed message text. If no message text has
been programmed for the selected number key, the radio
will display "NO ENTRY". A valid selection will permit the
message text to appear in the display for a pre-pro-
grammed time. After the time-out expires or the
m
key has been pressed (the m key will override the
time-out period), the message text is selected and will be
transmitted to the site. If the site does not receive the
message properly, the radio will sound a low pitched
tone.
If an incorrect message text was selected or the
incorrect number key was pressed, the message text
can be changed during the pre-programmed time-out
period by pressing another number key. The message
86