Extreme Networks WM-4T1i - Manual (Page 28)

3-2 WM-4T1i Module Installation and User Guide
Configuring PPP and MLPPP
Multilink PPP and Multilink Groups
Each multilink PPP group is given a name, up to 16 characters in length. All named
components of the switch configuration must have unique names, so multilink groups
and VLANs cannot have identical names. See the ExtremeWare Software User Guide for
more information on allowable names for named components. Components are named
using the
create command. Once a component is named, you do not need to use the
keyword for the component (see the shortcut below).
Create the multilink group using the following command:
create multilink
Once the multilink group is created, assign ports to it by using the following command:
config multilink add ports
or you can use the following shortcut:
config add ports
If the first port added to a multilink group is already configured for PPP, the multilink
group will inherit the configuration of the first port. Any other ports added to the link
will be configured to match the multilink configuration. The next section lists the
configuration commands for multilink groups and single PPP links.
Once the multilink group has been configured, it is added to a VLAN so that it can pass
traffic from the VLAN across the link. To add a multilink group to a VLAN, use the
following command:
config vlan add multilink
Typically the last step in configuring a multilink group is to use the following command
to enable it:
enable multilink
Any changes to an enabled multilink group will not take effect until the the multilink
group is restarted. To restart a multilkink group, use the following command:
restart multilink