Extron electronic MTPX Plus Series - Manual (Page 2)

Specifications — MTPX Plus Series, cont’d
Extron MTPX Plus Series Twisted Pair Matrix Switchers • Specifications 2
Max input voltage 5 0 Vp-p
Max propagation delay 60 ns total
Max rise/fall time 4 ns
Polarity Positive or negative
Audio
Routing
MTPX Plus 816 8 x 16 mono matrix, 3 x 4 local
MTPX Plus 168 16 x 8 mono matrix, 3 x 4 local
MTPX Plus 1616 16 x 16 mono matrix, 3 x 4 local
MTPX Plus 1632 16 x 32 mono matrix, 6 x 8 local
MTPX Plus 3216 32 x 16 mono matrix, 6 x 8 local
MTPX Plus 3232 32 x 32 mono matrix, 6 x 8 local
Gain (local inputs and outputs) Unbalanced output: 0 dB; balanced output: +6 dB
Frequency response 20 Hz to 20 kHz, ±1 dB
THD + Noise 0 15% @ 1 kHz at nominal level
S/N >70 dB at maximum output (unweighted)
CMRR >43 dB @ 20 Hz to 20 kHz
Audio input— local
Number/signal type 3 or 6 stereo, balanced/unbalanced
Connectors (3) or (6) 3 5 mm captive screw connectors, 5 pole
Impedance >10k ohms unbalanced
Nominal level +4 dBu (1 23 Vrms), -10 dBV (316 mVrms)
Maximum level +18 dBu, (unbalanced) at 1% THD+N
N 0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu
Audio input — main (see transmitters' output specifications)
Number/signal type 8, 16, or 32 proprietary analog signals
Connectors 8, 16, or 32 (depending on configuration) female RJ-45 connectors
Audio output— local
Number/signal type 4 or 8 dual mono, balanced/unbalanced
Connectors (4) or (8) 3 5 mm captive screw connectors, 5 pole
Impedance 50 ohms unbalanced, 100 ohms balanced
Gain error ±1 dB channel to channel
Maximum level (Hi-Z) +18 dBu, balanced or unbalanced at 1% THD+N
Maximum level (600 ohm) +15 dBm, balanced or unbalanced at 1% THD+N
Audio output — main (see receivers' input specifications)
Number/signal type 8, 16, or 32 proprietary analog signals
Connectors 8, 16, or 32 (depending on configuration) female RJ-45 connectors
Control/remote — switcher host control
Serial host control ports 1 RS-232 or RS-422, rear panel 9-pin female D connector
1 RS-232 front panel 2 5 mm mini stereo jack
Baud rate and protocol 9600 baud (default), 19200, 38400, and 115200 (adjustable); 8 data bits; 1 stop
bit; no parity
Serial control pin configurations
9-pin female D connector RS-232: 2 = TX, 3 = RX, 5 = GND
RS-422: 2 = TX-, 3 = RX-, 5 = GND, 7 = RX+, 8 = TX+
Mini stereo jack Tip = TX, ring = RX, sleeve = GND
Ethernet control port 1 RJ-45 female connector