Elinchrom SCANLITE 20998 - Manual (Page 6)

EN
6
User Manual
BEFORE YOU START
• Ensure that the SCANLITE is switched OFF and the mains plug is removed, before
mounting the halogen lamp.
• Ensure that the halogen lamp voltage and the fuse correspond to the mains voltage
110 V or 230 V
• Ensure that the SCANLITE is in a workable condition. Do not use the SCANLITE if the
cable, fan or the housing show any kind of damage.
ATTENTION
• Always switch the SCANLITE off and wait until the unit cooled
down, before replacing halogen lamps or accessories! Note; for
faster cooling of the halogen lamp and the SCANLITE, switch the
light off, with the ON / OFF switch on the top of the head. The
fan cooling is active, wait 5 minutes at least, before removing the
mains plug.
• The ambient temperature whilst the unit is in use: min. -20°C
(-4°F) up to max. 35°C (95°F)
THIRD PARTY MANUFACTURERS
Use only original Elinchrom accessories and reflectors. The warranty does not cover
damages forced by third party accessories and reflectors.
• Halogen lamps may generate high pressure during operation. Explosions may occur
with aged halogen lamps and incorrect fuse. For this reason the lamp is covered with a
glass dome.
• Damaged cables, glass domes and cases must be immediately replaced by customer
service.
SAFETY NOTE FOR ACCESSORIES
• Rotalux softboxes and umbrellas are limited to 300 W halogen lamps.
• Metal reflectors can be used with 650 W halogen lamps, except small or narrow
reflectors such as snoots and grids for Reflectors, which can be damaged or even
burned by the excessive heat of the halogen lamp.
• Not used SCANLITE’s should be switched off.
• Ensure that the ventilation system of the SCANLITE works correctly.
• No guarantee when materials are misused or damaged by excessive heat.