Electrolux EFC 9441 User Manual

Page 9

electrolux

electrolux control panel 9

Filter checking device

The cooker hood is fitted with a
device which indicates when the filter
must be cleaned or replaced.
Usually the device, which signals
when the carbon filter needs
maintenance work, is deactivated

deactivated

deactivated.

To activate it, proceed as follows:
Switch off the cooker hood.
Press the knob and rotate it by 90° in
a clockwise direction.
The L2

L2 LED begins to flash in green

and after approximately 2 seconds
the L2

L2 LED will also begin to flash in

orange, to indicate that the device,
which indicates when it is necessary
to perform carbon filter maintenance,
has been activated

activated

activated.

L2 LED - gr

L2 LED - grease filter indicator

ease filter indicator

The LED lights up in green when the
grease filter needs to be cleaned; this
happens approximately every 40
hours of operation.
Every time the cooker hood is used,
check whether the L2

L2 LED is lit.

L2 LED - carbon filter indicator

The LED lights up in orange when
the carbon filter needs to be cleaned/
replaced; this happens approximately
every 160 hours of operation.
Every time the cooker hood is used,
check whether the L2

L2 LED is lit.

Resetting the filter saturation war

Resetting the filter saturation warning

ning

After cleaning or replacing the filters,
switch on the cooker hood at any
suction speed (power), then press
and hold the knob for more than 3
seconds, until you hear a beep
indicating that the reset procedure
has been performed successfully.
The L2

L2 LED and the cooker hood

both switch off.
In some situations (for example,
when the L2

L2 LED is indicating that

the grease filters and the carbon filter
are saturated), the procedure
described above must be repeated.

This manual is related to the following products:

EFC 6441